Cisco AIR-PWRINJ-60RGD1 Series Installation Instructions Manual page 10

Pole Mounting the Power Injector Using AIR-PWRINJ-60-PMK=
Mount the power injector on pole bracket. The power injector has three mounting holes, one on the top
Step 3
end and two on the bottom end, that you can use to secure it to the pole bracket (see
the power injector using these screw holes and the three M5X16 countersunk head screws.
Ground the power injector, using the ground wire shipped with the power injector. Attach one end to the
Step 4
Earth Ground connector on the head of the power injector (see
permanent ground connection.
Proceed with the
Step 5
Figure 5 Pole-Mounting the Power Injector
Cisco Aironet Series Power Injectors AIR-PWRINJ-60RGD1= and AIR-PWRINJ-60RGD2= Installation Instructions
10
"Connecting Data and Power to the Injector" section on page
Figure
Figure 1), and attach then other end to a
11.
4). Mount