Advertisement
Figure 2
Figure 2
Unpacking the Power Injector
The typical power injector package contains the following items:
•
•
•
If any item is missing or damaged, contact your Cisco representative or reseller.
Additional Requirements
Use the power cord that shipped with your power injector to supply power for the injector. If you install
the access point in an environmental air space such as above a suspended ceiling, check national and
local safety codes to make sure that the Ethernet cable you connect to the unit meets applicable
standards.
Note
The AIR-PWRINJ5 is not plenum and should not be installed in the plenum airspace.
Note
The maximum distance that is supported for in-line power is 328 ft. (100 m), including the length of the
6.5-ft. (2-m) Ethernet cable provided with the power injector.
Installing the Power Injector
Follow these steps to install the power injector:
1.
shows a typical installation scenario.
Power Injector AIR-PWRINJ5 Installation Scenario
Access point
Power injector
Power cord
URL Pointer Card and China RoHS Statement
Plug a Category-5 Ethernet cable into the port on the power injector labeled AP.
Network source
SYST
1
RPS
2
3
4
STAT
5
UTIL
DUPLX
SPEED
6
7
8
9
10Base -T
MODE
10
/ 100Bas
e-TX
11
12
13
14
15
16
17
18
Cataly st 2950
19
20
SERIES
21
22
23
100Bas e-FX
24
23
24
Cisco Aironet Power Injector (AIR-PWRINJ5) Installation Guide
Installing the Power Injector
Power injector
Power
cord
3
Advertisement
