Multi-Scan Mode; Comparison Mode - RJS Inspector D4000 Operator's Manual

Inspector D4000™ Laser

7.1 Multi-scan mode

When multi-scans are selected, the number of remaining scans needed to complete the analysis
are displayed:
*0192837465*
03 Scans Remain
The resulting analysis is an average of the scans. Press the Select to view the Results screen:
*1234ABCD*
Code 3of9
D/bility %
D/bilGrade 3.7 A
After the last scan a double beep or chirp will signal completion of the scan.

7.2 Comparison Mode

The first bar code scanned after turning Comparison Mode On will be saved as the "Master" bar
code. All bar codes scanned will be compared to the "Master" bar code and if the encoded data
does not match then the following screen will be displayed.
No Match
Note:
To enter a new "Master" bar code, toggle the Comparison
Mode selection to Off and then to On again.
RJS, Minneapolis, MN
Operator's Guide
.59
002-7858
18