Axis T6112 Repainting Instructions page 3

AXIS T6112 Audio and I/O Interface
How to repaint the product
How to repaint the product
Preparations
NOTICE NO NO TICE TICE
Do not remove the microphone from the cover. Make sure to mask it properly.
• If applicable, disassemble the equipment according to the instructions in this document.
• Clean all parts to be repainted thoroughly to remove grease, dust or oil.
• To ensure reassembly and functionality of the product, mask openings for screws, LED indicators, or microphones before
painting.
Pretreatment of parts
Depending on the part material and type of paint applied at factory, different pretreatments should be done for the new paint to
adhere as well as possible. For all variants though, proper cleaning to remove oil, grease and dust is strongly recommended.
For more information on the materials used in the product, see its datasheet at www.axis.com
Powder coated parts - Using fine sandpaper, remove the original powder coating down to the base material and clean the parts
before painting, or use a primer.
Anodised and chromated parts - Use a primer.
Uncoated stainless steel - No special pretreatment is needed, but make sure that the surface is clean before painting.
Plastic - Use a primer.
3