Whirlpool ACE184XR0 Use And Care Manual page 7

4. Adjust the cabinet until the distance on each side is the same.
Then add " (3.2 mm) for the final measurement to be used
in the next step.
A. Window sash
B. Empty cabinet
C. Window channel
5. Use final measurement to measure in from each edge of the
filler board. Mark lines in such a way that the outside edges of
the filler board will contain the screw holes.
6. Place cardboard or other protective material on a sturdy, flat
surface. Position filler board on top of the protective material
to keep from cutting into the surface below.
7. Place a ruler or straight edge along the lines drawn previously
and use a utility knife to cut filler boards to size along the
lines. Make cut so the outside edges of filler boards will have
screw holes.
C
A. Lines
B. Screw hole
8. Pull cabinet part way out of window. Attach right filler board
to front of a side-mounting angle with two
screws.
A. Right filler board
B. Side-mounting angle
C. " hex-head screw
A
B
C
A
B
D
C. Long edge
D. Short edge
" hex-head
B
A
C
Top View
9. Place cabinet back into the window with right filler board tight
against window channel. Insert left filler board into window
channel.
Top View
A B
A. Right filler board
B. Window channel
10. Push left filler board against side-mounting angle and attach
with two " hex-head screws. From the outside, push filler
boards as far forward in window channels as possible.
Foam block installation
1. Measure the distance between the channel edge and the filler
board.
2. Cut foam blocks " (6.4 mm) wider and insert into channel
behind filler boards.
Top View
A
A. Filler board
B. Window channel
C. Foam block
Outside View
A
C
A. Window channel
B. Filler board
C. Foam block
A
B
C
B
B
7