Table of Contents
Advertisement
Uni-P Pro 200X Dehumidifier
Unit Diagram
Control Panel
Pre-Filter
Discharge Grille
Power Cord
Maintenance
**For more detailed instructions, visit www.unipdry.com**
WARNING: Always unplug the unit before doing any maintenance.
Cleaning the Machine Body
• Use a soft, damp cloth to clean the exterior of unit. Do not use any
soap or solvents
Coil Maintenance
Once per year, clean the coils with an approved coil cleaner. The coil cleaner should be a self-rinsing,
foaming, cleaner, such as WEB® Coil Cleaner.
Tel: 888-990-7469
Installation, Operation & Service Instructions
Handle
Filter Cover
Side Panel
Drain Hose
Connection
Auxiliary Terminals
8
Uni-P Pro 200X Dehumidifier
Cleaning the Filter
1. Unplug the unit.
2. For PreFilter:
a. Remove prefilter from inlet of machine.
b. Vacuum or wash with warm water (no soap).
3. For MERV-10/HEPA/Carbon Filters:
a. Replace as necessary- we recommend checking the filters
at least 1x/year
Electrical Access
•
Unscrew the 13 screws on the side panel.
• Remove the screw on the
control board cover.
Pump Maintenance
Your Unip Pro 120X is equipped with an integral condensate pump designed to pump
water from the dehumidifier out to the desired drain. The pump requires routine maintenance
that is not covered by the warranty.
Preventative maintenance is necessary to prevent issues from dirt and slime that may
accumulate in the drain system. This includes the drain pan, hose to the condensate pump,
pump reservoir, pump head assembly, and discharge tubing
Removing the Pump
1. Remove the 13 screws on the side panel and set panel aside.
2. Remove the screw holding the pump in place.
3. Undo the 3 pump electrical quick connects and 1 drain quick connect
4. Insert a flat head screwdriver into the notch
on the side of the pump. This will allow you to
gently lift the pump off its reservoir (the reservoir
remains attached to the unit)..
9
Installation, Operation & Service Instructions
Tel: 888-990-7469
Advertisement
Table of Contents
