Table of Contents
Advertisement
Trouble shooting
:
Risk of injury!
Incorrect repairs may cause serious hazards. Repairs to the
appliance must only be carried out by a qualified technician. If
repairs are required, contact the after-sales service.
Fault table
Fault
The appliance does not work.
Zeros flash in the display.
The oven light has failed.
The oven does not heat up.
All dishes that are prepared in the
oven burn within an extremely
short period of time.
The door panel steams up when
the oven is hot.
Replacing the oven light bulb
If the bulb in the oven light fails, it must be replaced.
Replacement heat-resistant bulbs can be obtained from the
after-sales service or from specialist retailers. Please supply
your appliance's E number and FD number. Do not use any
other type of bulb.
:
Risk of electric shock!
When replacing the cooking compartment bulb, the bulb socket
contacts are live. Before replacing the bulb, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box.
Pull out the mains plug or switch off the circuit breaker.
1.
Open the appliance door.
2.
When the oven is cold, place a tea towel inside to prevent
3.
damage.
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers
can be found on the right-hand side of the oven door. You can
make a note of the numbers of your appliance and the
telephone number of the after-sales service in the space below
to save time should it be required.
T r o u b l e s h o o t i n g
Possible cause
The circuit breaker is faulty
Power cut
Power cut
Faulty oven light
Faulty fuse.
The function selector has not been set. Set the function selector.
Faulty thermostat
Normal occurrence; caused by the dif-
ference in temperature
Remedy/information
Look in the fuse box and check that the circuit
breaker is in working order.
Check whether the kitchen light works.
Reset the time.
Change the oven light bulb. (See section "Replacing
the oven light")
Check and, if required, replace the circuit breaker.
Call the after-sales service.
Not possible; this has no effect on oven performance.
Remove the glass cover for the defective oven light in the
4.
cooking compartment.
Replace the oven light bulb with one of the same type.
5.
Voltage: 230 V;
Power: 25 W;
Thread: E14;
Temperature resistance: 300 °C
Put the glass cover for the oven light bulb back on.
6.
Remove the tea towel and switch the circuit breaker back on
7.
or plug the mains plug in again.
Switch on the oven light and check that it is working correctly.
8.
E no.
After-sales service
O
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
After-sales contact details for all countries can be found in the
attached after-sales service directory.
FD no.
19
Advertisement
Table of Contents
