Bell Schedule; New Bell Schedule; All Bell Schedule - Magic PM160 User Manual

Bell Schedule

Many companies need a bell for on-duty and off-duty. Some uses manual bell and some uses
electronic. To save cost and provide convenience to management, we integrate bell functions to
fingerprint sensor. You can set the time for the bell. When it is the scheduled time, the device will
automatically play the selected ringtone and trigger the relay signal. The ringtone playing does
not stop until the ringing duration has elapsed.

New Bell Schedule

Enter into "Personalize""Bell Schedules""New Bell Schedule"

All Bell Schedule

For editing the scheduled bells
Voice Prompt: This parameter is used to set
whether to play voice prompts during the
operation of the FFR terminal. Select "ON" to
enable the voice prompt, and select "OFF" to
mute.
Keyboard Prompt: This parameter is used to set
whether to generate beep sound in response to
every keyboard touch. Select "ON" to enable the
beep sound, and select "OFF" to mute.
Volume: This parameter is used to adjust the
volume of voice prompts.
Bell Status: Enable/Disable this bell.
Bell Time: The bell rings automatically when it is
the specified time.
Repeat: Specifies whether to repeat the ringtone.
Bell Type: You can select between internal ringing
and external ringing. For internal ringing, the ring
tone is played by the loudspeaker of the terminal.
For external ringing, the ring tone is played by an
external electric bell that is wired with the
terminal.
Ring Tone: Bell ring
Internal bell delay (s): Specifies the duration for
ringtone play. The value ranges from 1 s to 999s.
P160 User Manual 21