Communication Setting; Ethernet - Magic PM160 User Manual

8. Communication Setting

Set communication parameters. Enter into "Comm."

Ethernet

Enter into "Comm.""Ethernet"
1. Ethernet: The device can communicate with
PC each other via the parameters you set.
2. Serial Comm: The device can communicate
with PC each other via the serial port
parameters you set.
3. PC Connection: Set the password and device
ID so that you can connect the device with
software in PC.
4. Wireless Network：Turn on /off the WIFI
setting.
5. ADMS: Settings used for connecting with
ADMS server'
6. Wiegand Setup: The device can
communicate with other device via the
parameters you set.
1. IP Address: Modify it if necessary. It cannot be
same with PC.
2. Subnet Mask: Modify it if necessary.
3. Gateway: It is necessary to set an address if
the device and PC are in different network
segment. Modify it if necessary.
4. DNS: Set the address of your DNS server.
5. TCP COMM Port: Set the TCP communication
port.
6. DHCP: Dynamic Host Configuration Protocol,
which is used to allocate dynamic IP addresses
to clients by a server.
7. Display in Status Bar: Whether to display
network status icons in the status bar.
P160 User Manual 15