Regulatory Information - Honeywell FocusPro 6000 Operating Manual

Regulatory Information

FCC Compliance Statement (Part 15.19) (USA only)
This device complies with Part 15 of FCC Rules. Operation is subject
to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including
interference that may cause undesired operation.
FCC Warning (Part 15.21) (USA only)
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
FCC Interference Statement (Part 15.105 (b)) (USA only)
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Exposure Limits
To comply with FCC and Industry Canada RF exposure limits for gen-
eral population/uncontrolled exposure, the antenna(s) used for this
transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter.
Industry Canada Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1 this device may not cause interference, and
2 this device must accept any interference, including interference
that may cause undesired operation of the device.
Limites d'exposition
Pour être conformes aux limites d'exposition aux radiofréquences
établies par la FCC et Industrie Canada pour le grand public/
l'exposition non contrôlée, la ou les antennes employées par le
transmetteur doivent être installées sur une structure extérieure per-
manente à au moins 20 cm de distance de toute personne et ne peu-
vent être situées au même endroit qu'une autre antenne ou un autre
transmetteur ou fonctionner conjointement avec une autre antenne
ou un autre transmetteur.
Industrie Canada Alinéa 7.1.5 de CNR-GEN
Le fonctionnement de ce système est assorti aux deux conditions
suivantes :
1 L'appareil ne peut causer d'interférences nuisibles, et
2 L'appareil doit accepter les interférences reçues, y compris celles
qui pourraient nuire à son fonctionnement.
43
Control remoto
69-2054EFS—05