Honeywell Silent Knight 6860 Product Installation Document

6860
Remote Annunciator
Product Installation Document
1 Description
The 6860 is an optional 4x40 remote annunciator that can be surface or
flush-mounted.
BACK
NEXT
Figure 1 6860 Remote Annunciator
1.1 Compatibility
The 6860 is compatible with the Silent Knight Series FACPs. For more
information, refer to the FACP Manual.
1.2 Specifications
Operating Voltage:
Current Standby Current: 27mA
Alarm Current:
Operating Temperature:
Dimensions Flush Mount:
Surface Mount:
Table 1 Specifications
Document LS10174-001SK-E:B
BACK BACK
NEXT NEXT
Model 6860
24VDC
53mA
32° to 120° F (0° to 49° C)
Overall:
12.25" W x 11.5" H x 0.875" D
(31.1 cm W x 29.2 cm H x 2.2 cm D)
Backbox: 9.25" W x 8.375"H
(23.5cm W x 21.27cm H)
Including trim ring:
12.25" W x 11.5" H x 3.0" D
(31.1 cm W x 29.2 cm H x 7.6 cm D)
2/15/2022 ECN: 151062
2 Installation
1. Ensure power is turned off at the panel.
2. Mount the 6860 in the desired location. See Section 2.1.
3. Connect the 6860 to the panel. See Figure 5.
4. Use the DIP switches on the back of the 6860 to assign an ID
number. Refer to the FACP manual.
5. The 6860 module must be added to the system through FACP
programming. JumpStart can be used to automatically add the
module or it may be added manually. Refer to the FACP Manual for
more information.
2.1 Mounting
2.1.1 Flush Mounting
Follow these steps to flush mount the 6860.
1. The backbox dimensions are 9.25" W x 8.375" H. The minimum
depth required is 2". Mount the backbox using the mounting holes
shown below.
mounting holes
mounting holes
Figure 2 6860 Backbox Mounting
2. Remove knockouts as needed for wires. There are 10 knockouts
available, two on each side and two in the back of the cabinet.
3. Wire the annunciator board to the main control panel as shown in
Figure 5.