Advertisement
Assembly Instruction Steps:
1. Place Top Unit (A) on a soft, scratch-free surface.
2. Slowly pull out the drawer box, as seen in the illustration below. Keep the drawer box for later use.
3. Align the pre-drilled holes found on 1 of the Frame Legs (B), to the wooden dowels located on the side
panel of the Top Unit (A), as seen in the illustration below.
4. Secure from the interior of Top Unit (A): 4 sets of Bolt (E), Spring Washer (F), and Flat Washer (G) into the
pre-drilled holes located on the Frame Leg (B).
5. Tighten loosely with the supplied Allen Key (D).
E
F
G
6. Slide both of the Shelves (C) into the grooves of Frame Leg (B), with the pre-drilled holes facing
downwards, as seen in the illustration below.
7. Secure (2) Wood Screws (H) into the pre-drilled holes at the bottom of each Shelf (C).
8. Tighten the Wood Screws (H) with the Phillips Head Screwdriver. Do not over tighten.
9. Assemble the remaining Frame Leg (B) to the Top Unit (A) and Shelves (C) by aligning the pre-drilled
holes of the Frame Leg (B) to the wooden dowels (located on the side panel of the Top Unit). Make sure
the Shelves (C) go into the grooves of Frame Leg (B) at the same time.
10. Secure from the interiors of Top Unit (A): 4 sets of Bolt (E), Spring Washer (F), and Flat Washer (G) into
the pre-drilled holes located on Frame Leg (B), as seen in the illustration below.
11. Loosely tighten with Allen Key (D).
Date: 2013-May-31
Rev:
4x
4x
4x
www.pbteen.com
G
F
Page 3 of 4
Advertisement
