Table of Contents
Advertisement
PROBLEMS AND SOLUTIONS
RADIATOR DOES NOT GET WARM
1- Radiator may not be receiving electricity. Be sure of the electrical connection.
The fuse might have been thrown out. If the fuse blows, always unplug the
radiator.
2- The thermostat may be set to a low temperature level at '' 0 '' in closed
position. turn the temperature setting knob clockwise to set the temperature to a
higher level.
If the problem still persists, contact MAKTEK AUTHORIZED SERVICE.
SAFETY TERMOSTADS
There are two safety thermostats in the radiator set to 100 ° C. These
thermostats cut off the heating circuit at 100 ° C fluid temperature in case of
overheating of the radiator, resulting in a constant current flow to the resistors due
to any reason. In this case, each of the red warning lamps located at the top of the
control panel illuminates when the safety thermostat connected is off.
:
WARNING
The commissioning of the safety thermostat means that there is an
overheating and a serious problem in the system. If you notice that one of the fault
warning lamps is on, turn off the radiator immediately, remove the plug from the
outlet, and consult the MAKTEK AUTHORIZED SERVICE.
12
Advertisement
Table of Contents
