Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Maktek TYPE 3100
Summary of Contents for Maktek TYPE 3100
- Page 1 ELECTRICAL PANEL RADIATOR USING AND INSTALLATION MANUAL...
-
Page 2: Table Of Contents
CONTENT 1- GENERAL INFORMATION…..................… 2 2- SAFETY WARNINGS ... …..................…... 3 3- MEASURES AND CAPACITIES.................. 5 4- WALL MOUNTING OF THE RADIATOR ..............6 5- BEFORE THE FIRST START ............…....9 6- FIRST START ...................…..10 7- PROBLEMS AND SOLUTIONS…………............….. 12 8- SUGGESTIONS FOR ENERGY SAVING ............…..…... -
Page 3: 1- General Information
This guide is prepared for receiving the highest efficiency from this product. Read all the warnings in this manual before using the device. Please contact only MAKTEK AUTHORIZED SERVICE in case of any problem with the radiator. You should take a few minutes to read the SAFETY WARNINGS section of this manual before you use the appliance for your own safety and others' safety. -
Page 4: 2- Safety Warnings
6- Never use the device with damaged plugs, electric cables. If the device is malfunctioning for any reason, do not try to turn it on again or try to open for repairing. Call MAKTEK AUTHORIZED SERVICES for electrical adjustment, repair, maintenance on the mechanical side. - Page 5 WARNING: DO NOT use the radiator NEVER in an leaning position. IMPORTANT: Always operate the radiator with a grounded socket.
-
Page 6: 3- Measures And Capacities
MEASURES AND CAPACITIES MODEL Power( kw ) Measures ( G*Y*B ) mm CURRENT DRAW ~ ( A ) TYPE 3100 98 * 300 * 1000 TYPE 3120 98 * 300 * 1200 TYPE 3140 98 * 300 * 1400 TYPE... -
Page 7: 4- Wall Mounting Of The Radiator
WALL MOUNTING OF THE RADIATOR 1- MOUNTING OF CARRIER CONSOLES ; Using a 10 mm drill bit on the wall where the radiator is to be mounted, 4 holes should be drilled with the measurements in figure-1 and indicated by 1-2-3-4 numbers. - Page 8 Figure – 2 Figure- 3...
- Page 9 Figure- 4 Figure- 5...
-
Page 10: 5- Before The First Start
Figure- 6 BEFORE FIRST START Radiator works with 230 V. 50 Hz. alternating current. Do not connect the device to an incorrect power source. Make sure that the mains voltage matches the operating voltage of the radiator. Always connect the radiator to an insulated and grounded power line. -
Page 11: 6- First Start
FIRST START IMPORTANT : This manual must be read and stored before operating the device. Once you have made sure that the radiator is properly installed in the wall and that you have read all the information and warnings in this manual, put the radiator plug in the prize. - Page 12 Each switch controls 2 resistors on the left and right of the radiator separately. If desired, a single resistor can be left in the circuit. Then turn the temperature control knob clockwise as shown in Figure-2. Bring it to a level you want and leave. It is stated in Table 2 that which radiator temperature corresponds to which of 5 different levels.
-
Page 13: 7- Problems And Solutions
If the problem still persists, contact MAKTEK AUTHORIZED SERVICE. SAFETY TERMOSTADS There are two safety thermostats in the radiator set to 100 ° C. These thermostats cut off the heating circuit at 100 °... -
Page 14: 8- Suggestions For Energy Saving
SUGGESTIONS FOR ENERGY SAVING 1- Many factors such as the environment and climatic conditions, the size of the space where the radiator will be used and the state of isolation and the installation method of the radiator are effective in achieving the expected efficiency from the radiator. -
Page 15: 9- Heat Transfer Liquid Specifications
HEAT TRANSFER LIQUID TECHNICAL SPECIFICATIONS he heat transfer fluid used in the Maktek electric radiator is resistant to oxidation even at very high temperatures (max 350 ° C) thanks to its additives. It is not corrosive, toxic and does not require renewal.