Advertisement
Aug-19
4. OPERATION
Fig 18
Installing Drills
1. Insert drill into chuck jaws approx. 1" (25.4mm) long. When using a
small drill do not insert too far for the jaws to tough the flutes of the
drill. Make sure that the drill is centred in the chuck before tightening
the chuck with the key.
Fig 19
Workpiece Positioning
1. Always place a piece of wood (or plywood) on the table to prevent
"splintering" and/or burrs on the underside of the workpiece as the
drill breaks through. Position the wood so that it is in contact with the
left side of the column
For small pieces that cannot be clamped to the table, use a drill press vice. The vice must be clamped or bolted to the
table.
5. INSPECTION
Prior to each use conduct a visual inspection checking for abnormal conditions, such as cracked welds, leaks, and
damaged, loose, or missing parts.
The drill press shall always be maintained in accordance with the maintenance instructions. No alterations or
modifications shall be made to this drill press.
Inspections shall be performed in accordance with this owner's manual.
The drill press must be inspected immediately if it is believed to have been subjected to abnormal load or shock.
Owners and /or operators should be aware that repair of this product may require specialised equipment and knowledge
(refer to maintenance section).
6. STORAGE
This drill press should always be stored in a dry location on a level surface with the power switched off.
7. MAINTENANCE
DISCONNECT Drill Press before performing any maintenance
FREQUENTLY blow out any dust that may accumulate inside the motor
APPLY a coat of automobile type wax or similar to the table and column to keep surface clean
LUBRICATION; all the ball bearings are packed with grease at the factory. They require no further lubrication
PERIODICALLY lubricate the gear and rack table elevation mechanism, the splines (grooves) in the spindle and the rack
(teeth on the quill)
Only use replacement parts that are approved by the manufacturer.
Regularly clean all surfaces and maintain all labels and warnings.
8. SERVICE & REPAIR
Any Borum Industrial Drill Press found damaged in any way, or found to be worn or operates abnormally should be removed
from service until repaired by an authorised service agent. Owners and / or operators should be aware that repair of this
product may require specialised equipment and knowledge. Only authorised parts, labels, decals shall be used on this
equipment. Annual inspection of the drill press is recommended and can be made by an authorised repair facility to ensure
that your equipment is in optimum condition and that the equipment has the correct decals and safety labels specified by the
manufacturer.
Made in China to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
Product Code: CH16NT
Page 9
Advertisement
