Download Print this page

Standard Operating Procedure - Borum CH16NT Owner's Manual

Pedestal

Advertisement

Aug-19

STANDARD OPERATING PROCEDURE

DO NOT use this machine unless you have been trained and assessed to a competent level in its sate use and operation, and
have been given permission to use this
Safety glasses must be worn when operating this
equipment
Safety footwear must be worn when operating
this equipment
Rings and jewellery must not be worn when
operating this equipment
Gloves must not be worn when machine is
operating. Machine to be at standstill if gloves
required for manual operations.
PRE-OPERATIONAL SAFETY CHECKS
1.
Keep guards in place and in good working order
2.
Keep drill press in good working order, follow lubricating and changing accessories instructions
3.
Use recommended accessories only, failure to do so may damage the drill press and/or may risk injury
4.
Remove adjusting keys & wrenches from the drill press before operating
5.
Ensure the switch is in the OFF position before starting the drill press
6.
Disconnect drill press before performing any maintenance
7.
Keep work area clean, free from hazards and well lit.
8.
Only use the drill press for its intended purpose.
9.
Wear the correct PPE clothing.
10. Secure work using claims or vice where practical.
11. Do not overreach, keep proper footing and balance at all times while operating the drill press
12. Never leave drill press running unattended, always lock the "on – off" switch when not in use
13. Use only on hard level surfaces capable of sustaining the load.
14. Ensure that risk assessment has been read.
15. Check workspace and walkways to ensure no slip-hazards are present.
16. Faulty equipment must not be used. Immediately report suspect equipment.
OPERATIONAL SAFETY CHECKS
1.
Never leave the machine running unattended.
2.
Before making adjustments or before cleaning sward accumulations switch off and bring the machine to a complete
standstill.
3.
Ensure that the work piece is securely held in a clamped work vice or clamped directly to the table.
4.
Feed downwards at a sufficient rate to keep the drill cutting.
5.
Feed with care as the drill breaks through the underside of the work.
6.
Use a safe working posture (beware of hair catching).
HOUSEKEEPING
1.
Switch off the machine.
2.
Return all tooling and fixtures to the correct storage location.
3.
Display a completed "Equipment in Use" notice if the machine is set up and/or in use but unattended.
4.
Leave the machine and work are in a safe, clean and tidy state after job is completed.
5.
Return surplus material to stock and dispose of waste material in an appropriate recycling or waste bin.
POTENTIAL HAZARDS
Hair/clothing entanglement – rotating spindle/drill
Eye injuries
High noise levels when drilling some materials
Removal or modification of safety devices
Made in China to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
Long loose hair must be contained when operating
this equipment
Close fitting/protective clothing must be worn
when operating this equipment
Hearing protection must be worn where noise
levels are in excess of 85 dB(A) occupational
exposure limit
Flying swarf/chips
Sharp edges and burrs
Distracting operator
Using equipment with lapsed test tag
Product Code: CH16NT
Page 3

Advertisement

loading