Aug-19
TROUBLESHOOTING
PROBLEM
Noisy Operation
Excessive drill wobble
Motor won't start
Drill binds in workpiece
Drill burns or smokes
Table difficult to raise
WARRANTY
BORUM Industrial products have been carefully tested and inspected before shipment and are guaranteed to be free from
defective materials and workmanship for a period of 12 months from the date of purchase except where tools are hired out when
the guarantee period is ninety days from the date of purchase.
Should this piece of equipment develop any fault, please return the complete tool to your nearest authorised warranty repair
agent or contact TQB Brands Pty Ltd Warranty team – warranty@tqbbrands.com.au.
If upon inspection it is found that the fault occurring is due to defective materials or workmanship, repairs will be carried out free
of charge. This guarantee does not apply to normal wear and tear, nor does it cover any damage caused by misuse, careless or
unsafe handling, alterations, accident, or repairs attempted or made by any personnel other than the authorised TQB Brands Pty
Ltd repair agent.
This guarantee applies in lieu of any other guarantee expressed or implied and variations of its terms are not authorised.
Your TQB Brands Pty Ltd guarantee is not effective unless you can produce upon request a dated receipt or invoice to verify your
proof of purchase within the 12month period.
Consumer Guarantee
Our goods come with a guarantee that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have
the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
POSSIBLE CAUSE
Incorrect belt tension
Dry spindle
Loose pulley
Loose belt
Bad bearing
Loose chuck
Worn spindle shaft or bearing
Bad chuck
Power supply
Motor connection
Switch connections
Motor windings burnt
Bad switch
Excessive pressure on feed handle
Loose belt
Loose drill
Speed too fast
Incorrect speed – reduce RPM
Fillings caught in drill bit
Poor drilling
Incorrect feed pressure
Needs lubrication
Bent rack
Table lock too tight
Made in China to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
REMEDY
Adjust tension
Remove spindle/quill assembly & lubricate
Tighten pulley
Adjust belt tension
Replace bearing
Tighten by pressing chuck down against table
Replace spindle shaft or bearing
Replace chuck
Check power cord
Check motor connections
Check switch connections
Replace motor
Replace switch
Apply less pressure
Check belt tension
Tighten drill with key
Change speed
Refer to RPM sheet
Clean drill bit
Sharpen drill bit or replace drill bit
Apply less pressure
Lubricate with a light oil
Straighten rack
Loosen clamp
Product Code: CH16NT
Page 12