Disconnect the bowden tube to the bowden tube holder by pushing down the blue ring
while gently pulling out the bowden tube.
2
Loosen the set screw that holds the filament guiding funnel inside the extruder assembly using
the Allen key. (Tool 1)
3
Pull out the filament guiding funnel.
4
Unscrew the bowden tube connector from the filament guiding funnel.
5
Place the flexible filament guiding modification into the extruder and push it down.
6
NOTE: You might need to tap it in gently.
H. Kamerlingh Onnesweg 10
2408 AW Alphen aan den Rijn
The Netherlands
(A)
A
4