Huawei SUN2000L User Manual page 75

SUN2000L-(2KTL-5KTL)
User Manual
Alarm Alarm Name
ID
2068 Battery
Abnormal
2075 Peripheral Port
Short Circuit
Issue 06 (2020-03-19)
Alarm Possible Cause
Severity
Minor Cause ID = 1



Warning Cause ID = 1
The SUN2000L Alarm port
is short-circuited when
supplying 12 V power to
peripheral.
Contact your supplier or Huawei technical support if all failure analysis procedures listed above are
completed and the fault still exists.
Copyright © Huawei Technologies Co., Ltd.
The battery is faulty.
The battery
communication is
interrupted.
The battery switch trips
when the SUN2000L is
running.
7 System Maintenance
Suggestion
1. If the battery fault indicator is
steady on or blinking, contact
the battery supplier.
2. Check that the battery
enable/power/communications
cable is correctly installed, and
that the communications
parameters are the same as the
SUN2000L RS485
configurations.
3. Check that Auxiliary Power
switch on the battery is on.
4. Send a shutdown command on
the app. Turn off the AC output
switch, DC input switch, and
battery switch. Then turn on
the battery switch, AC output
switch, and DC input switch in
sequence after 5 minutes.
5. If the alarm persists, contact
your supplier or Huawei
technical support.
1. Turn off the AC and DC
switches on the SUN2000L and
disconnect the peripheral from
the Alarm port. Then power on
the SUN2000L again and clear
the alarm manually. If the
alarm persists, contact your
supplier or Huawei technical
support to rectify the fault. If
the alarm is cleared, it indicates
that the port on the SUN2000L
is normal. Then check that the
pins in the power port on the
peripheral are not
short-circuited.
2. Replace the peripheral, and
then start a self-check to check
that the port functions properly.
69