Mitsubishi Electric CITY-MULTI PAC-PH01EHY-E Installation Manual page 18

8
L/XL-module
[Fig. 8.2.1.1]
<B>
C
D
<C>
<A> Fasten the panel heater wirings with the cable strap on the center front pillar together with the strong electrical
wiring.
<B> When performing <A> above, if the panel heater wirings are in contact
with the heat exchanger, refrigerant piping, and sheet metal edges,
wrap the supplied pipe cover around the pipe so that the wirings are
out of contact with them. Then, fix the wirings in place with a cable tie.
<C> Fasten the panel heater wirings with the cable strap for holding strong electrical wiring on the outside of the control
box together with other wirings.
<D> Thread the panel heater wirings through the cable hole at the lower part of the control box along with other wirings.
<E> Thread all wirings on the left through the hole below the control box.
ACenter front pillar
BCable strap for strong electrical wiring (on the center front pillar)
CPanel heater wirings
DCable strap for strong electrical wiring (on the outside of the control box)
18
<A>
B
8.2.1
A
<D>
D
<C>
<E>
Pipe Pipe cover
Cable tie Wire
Wiring fixing image