Mitsubishi Electric CITY-MULTI PAC-PH01EHY-E Installation Manual page 13

8
L-module
[Fig. 8.1.1.3]
A
Right side
[Fig. 8.1.1.4]
8.1.1
A
<A>
<B>
<A> Pull up the panel heater wirings so that the wirings run along the right rear pillar.
<B> Thread the panel heater wirings through the long hole on the right rear pillar.
<C> Pull the wirings from the end of the heat exchanger and bring them into the inner
side of the heat exchanger.
A Panel heater wiring
B Right rear pillar
C Right frame
D Heat exchanger fixing plate
E Wire seal
* If the wiring comes in contact with the edges of the heat exchanger fixing plate,
place the supplied wire seal.
A
<A> Screw down the metal sheet wiring cover at three points.
A Cover wiring 1
<A>
B Cover wiring 3
B
C
<C>
B
D *
E
13