Advertisement
Quick Links
Operation Manual
Thank you for choosing the Mini-Slider from Losi
™
. This guide contains the basic instructions for operating your new
®
Mini-Slider. While the Mini-Slider is great for first-time R/C drivers, it does require some mechanical experience and/or
parental supervision for drivers under 12. It is critical that you read all of the instructions in order to operate your
model correctly and avoid unnecessary damage. Please take a moment to look over all the printed materials before
operating your new Mini-Slider.
2007 Losi, A Division of Horizon Hobby Inc.
Slider 1.indd 1
5/2/2007 2:46:58 PM
Advertisement
Related Manuals for Team Losi mini-slider
Summary of Contents for Team Losi mini-slider
- Page 1 . This guide contains the basic instructions for operating your new ® Mini-Slider. While the Mini-Slider is great for first-time R/C drivers, it does require some mechanical experience and/or parental supervision for drivers under 12. It is critical that you read all of the instructions in order to operate your model correctly and avoid unnecessary damage.
- Page 2 27 MHz or 75 MHz frequencies and you will not receive any interference from them. the Mini-Slider operates on a radio signal you control, it is important for you to read and understand about all of these functions and adjustments before driving.
- Page 3 5. Remove the left side of the gearbox by removing the three screws. steering wheel. This is really helpful when you are on slick, as well as high traction, surfaces. If your Mini-Slider turns 6. Remove any shims on the bevel gears and set them aside so they can too sharply and/or spins out easily, try turning the steering rate down by rotating the knob counterclockwise (to the be reinstalled in the same location.
- Page 4 This would be good for short layouts or when running hotter motors. The pinion on the Mini-Slider offers the best balance of both. To change the pinion, remove the gear cover, loosen the...
- Page 5 LOSI DSM Radio System This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause unde- sired operation.