Table of Contents
Advertisement
INTENDED USE
The woodturning lathe is only used to work wood using a suitable turning iron.
The machine may only be used for its intended purpose. Any further use beyond this is not intended.
The user/operator and not the manufacturer is liable for any damage or injury of any kind resulting
from this.
Please note that our devices are not designed for commercial, technical or industrial use. We do not
assume any warranty if the device is used in commercial, craft or industrial enterprises as well as in
equivalent activities.
TECHNICAL DATA
Rated voltage:
Rated power:
Idling speed (engine):
Spindle speed:
Tip width:
Max. lathe diameter:
Protection type:
Weight:
Load factor:
The load factor S2 30 min (short-time operation) indicates that the motor with a rated power of 400
watts may only be continuously loaded for the time specified on the data plate (30 min). Otherwise it
would heat up excessively. During the pause, the motor cools down again to its initial temperature.
Danger! Noise and vibration:
The noise and vibration values were determined in accordance with EN 61029.
Operation
Sound pressure level LPA
Uncertainty KPA
Sound power level LWA
Uncertainty KWA
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
230 V ~ 50 Hz
400 Watt S2 30 min
1400 rpm
890/1260/1760/2600 rpm
ca. 1000 mm
max. 280 mm
IP20
ca. 23 kg
61 dB(A)
3 dB
74 dB(A)
3 dB
Seite 23
Advertisement
Table of Contents
