Table of Contents
Advertisement
Do not calibrate near bulk metal.
Do not calibrate the compass indoors.
Calibration procedure:
Caution
Please vacate the venue and follow the steps below to calibrate the compass. It is recommended that the
calibration be performed with no liquid in the pesticide tank.
1. Click Compass Calibration on the Magnetic Compass Calibration page in the APP, then enter calibration
mode.
2. Rotate the aircraft 360° horizontally. When the status indicator of the aircraft is steady green, horizontal
calibration is successful.
3. With the nose of the aircraft facing upwards, rotate 360° horizontally. When the red, yellow, and green
indicators flash alternately, the vertical calibration is successful.
4. Complete the calibration. If the aircraft status indicator flashes alternately red, yellow and green, it means
that the calibration was successful and you need to power on again. If the status indicator of the aircraft shows a
steady red light, it means that the calibration failed. Please power off and restart, and follow the above steps to
recalibrate the compass.
Need to recalibrate:
1. The magnetic compass is abnormal, and the aircraft status indicator shows that the yellow light flashes
rapidly or the red light flashes rapidly.
2. The site of this flight is far away from the site where the magnetic compass was calibrated last time.
3. The mechanical structure of the aircraft has changed.
4. The route is not straight during flight.
3.1.5 Setting Control Parameters
Click "Switch settings" in the upper left corner, and you can follow the instructions to read and adjust
parameters such as sensitivity.
Figure 3-15
24
Advertisement
Table of Contents
