Setting White Balance Adjustments; Resetting The Tv To Factory Condition; Resetting The Tv To Factory Condition Using Service Mode - Sony KDL-32EX655 Service Training Manual

SETTING WHITE BALANCE ADJUSTMENTS

White Balance adjustment data is located on the Digital Service Menu.
2
11. Press to move to 006 WB Category.
VPC
006
000
12. To change the data value of the R_DRV, press
6
value or to decrease the value.
NOTE: The data value must be set between the range 1 to 255.
1
13. Press to move to the next item (001 G_DRV).
14. To change the data value, press
decrease the value.
15. Repeat steps 6 and 7 for each of the following items:
002 B_DRV
003 R_BKG
004 G_BKG
005 B_BKG
16. To save the changes, press
17. Exit service mode by turning the TV power off.

RESETTING THE TV TO FACTORY CONDITION

Use the following instructions to restore the User Adjustments and Channel
Memory settings to the preset factory conditions.
1. Turn the TV On by pressing
40 to 60 seconds.
2. While holding down the
POWER
button on the side of the TV.
KDL-32EX655/40EX655/46EX655
SECTION 5 - UPDATES AND ADJUSTMENTS
SERVICE
WB
R_DRV 128
3
to increase the
3
to increase the value or
MUTING 0
then press
POWER
, then wait approximately
on the Remote Commander, press the
3. The set restarts and displays the Initial Setup screen. This may
take several minutes.
RESETTING THE TV TO FACTORY CONDITION USING
SERVICE MODE
1. Take the TV out of deep Standby mode by pressing
turn on the TV.
2. Press
3. Press the following buttons on the Remote Commander within a
6
to
second of each other:
DISPLAY
4. If necessary, press
5. Press the following buttons on the Remote Commander within a
second of each other:
Press
SERVICE changes to green RST.
.
RST executes the command and displays EXE.
EXE-RST displays green, then red indicating the TV is writing the
data.
POWER
to turn the TV back off.
5
Channel Volume
JUMP OPTIONS
or
8 MUTING 0
.
POWER
to
+ POWER
to go to DIGITAL menu.
40