Troubleshooting Table - BAT Screeny 130 Series Instruction Manual

Instruction manual

6.1 - Troubleshooting Table

All safety requirements must be followed in the event of faults or troubleshooting, particularly
when troubleshooting or repairing faults in the electrical components, where there is a risk of potentially
fatal electrocution. Maintenance on the electrical components must be performed only by qualified
technicians.
For faults not listed in the following tables, contact Technical Support.
MANUAL AWNING
PROBLEM
Fabric does not roll up evenly (forms cone) Arms not symmetrical
MOTORISED AWNING
Without electronic control unit
PROBLEM
Fabric does not roll up evenly (forms cone)
The fabric does not roll up completely
The awning does not open completely
The motor is very noisy
The motor stops after 4-5 minutes of contin-
uous operation
With electronic control unit
PROBLEM
The awning will not move
The awning movement is intermittent (e.g.
unrolls for 50 cm then stops)
The awning does not close in strong wind
The awning does not close in heavy rain
The awning opens and closes on its own
with a remote control system
23.07.15 - rev.03
CAUSES
Fabric not of even thickness
CAUSES
Arms not symmetrical
Fabric not of even thickness
Incorrect end stop regulation
Motor crown wheel shifting during operation
Wiring error
Faulty motor
Motor thermal cutout
CAUSES
Blown fuse
Wiring error
Faulty wind meter
Blown fuse
Faulty wind meter
Blown fuse
Faulty rain gauge
Flat battery
Damaged remote control
9
Screeny 130 Line
SOLUTIONS
Contact Technical Support
Roll up the fabric completely
SOLUTIONS
Contact Technical Support
Roll up the fabric completely
See Motor Man. (supplied as annex)
See Assembly Man., Chapter 7
See Motor Man. (supplied as annex)
See Motor Man. (supplied as annex)
Let the motor cool down for a few min-
utes
SOLUTIONS
Replace fuse following indications in the
manual supplied as an annex
See Motor Man. (supplied as annex)
See instructions for automatic devices
(supplied as annex)
Replace fuse following indications in the
manual supplied as an annex
See instructions for automatic devices
(supplied as annex)
Replace fuse following indications in the
manual supplied as an annex
See instructions for automatic devices
(supplied as annex)
Replace remote control battery (see
Controls instructions)
Replace the remote control