Table of Contents
Advertisement
Quick Start Guide
3
Location Anchor configuration
3.1
Safety messages
WARNING
Failure to follow these installation guidelines could result in death or
serious injury.
Ensure only qualified personnel perform the installation.
Explosions could result in death or serious injury.
Before connecting a handheld communicator in an explosive atmosphere,
ensure the instruments are installed in accordance with intrinsically safe or
non-incendive field wiring practices.
Verify that the operating atmosphere of the transmitter is consistent with
the appropriate hazardous locations certifications.
Electrical shock could cause death or serious injury.
Use extreme caution when making contact with the leads and terminals.
This Location Anchor complies with Part 15 of the FCC Rules. Operation is
subject to the following conditions: This Location Anchor may not cause
harmful interference. This Location Anchor must accept any interference
received, including interference that may cause undesired operation.
This Location Anchor must be installed to ensure a minimum antenna
separation distance of 20 cm from all persons.
3.2
Location Anchor configuration
Remove the Location Anchor electronics cover and connect to the HART
Communication terminals for configuration.
The Emerson Location Anchor will receive HART Communication from any
HART handheld Field Communicator or AMS Device Manager.
AMS Device Manager
AMS Device Manager can connect to devices directly, using a HART modem,
or remotely using the Gateway. To configure the Emerson Location Anchor,
double click (or right click and select Configure/Setup) on the device icon
that will appear below either the HART modem or Gateway connection tree.
8
February 2020
®
Emerson.com
Advertisement
Table of Contents
