Standards - Siemens Sinamics PM250 Hardware Installation Manual

Appendix

9.3 Standards

9.3 Standards
European low-voltage directive 2006/95/EC
The SINAMICS G120 product series meets the requirements of the low-voltage directive
2006/95/EC. The devices are certified that they comply with the following standards:
EN 61800-5-1 - Semiconductor power inverters - General requirements and line-commutated
inverters
European machinery directive 2006/42/EC
The SINAMICS G120 inverter series does not fall within the area covered by the Machinery
Directive. However, the use of the products in a typical machine application has been fully
assessed for compliance with the main regulations in this directive concerning health and
safety. A declaration regarding the acceptance is available upon request.
European EMC directive 2004/108/EC
When installed in accordance with the recommendations specified in this manual, the
SINAMICS G120 complies with all regulations of the EMC Directive according to the
definition provided by EN 61800-3 "EMC Product Standard for Power Drive Systems".
ISO 9001
Siemens AG uses a quality management system that meets the requirements of ISO 9001.
Underwriters Laboratories
The DEVICE is LISTED by UL and CUL for POWER CONVERSION in an environment with
the pollution degree 2.
You can find up-to-date information about the Power Modules at
http://support.automation.siemens.com/WW/view/en/30563173/133400.
SEMI F47
Specification for semiconductor process equipment voltage drop immunity
SINAMICS G120 Power Modules PM250 meet the requirements of the standard
SEMI F47-0706.
KC (Korea)
Inverters with the KC marking satisfy EMC requirements for South Korea. For details, see
EMC limit values in South Korea (Page 67).
90
Hardware Installation Manual, 01/2016, A5E36265179B-AA
PM250 Power Module