Table of Contents
Advertisement
SC2-AT6 – UserManual
Specifications subject to change without notice. | Tox_D_1119, Ex_D_1119, CO2_D_0320 | USA 200413 | Page 17 of 17
11 Part Disposal
Observe all disposal codes.
12 Notes and General Information
It is important to read this user manual thoroughly and clearly in order to understand the information and instructions.
The SC2 / AT6 devices must be used within product specification capabilities. The appropriate operating and
maintenance instructions and recommendations must be followed.
Due to on-going product development, INTEC Controls reserves the right to change specifications without notice. The
information contained herein is based upon data considered to be accurate. However, no guarantee is expressed or
implied regarding the accuracy of these data.
13 Intended Product Application
The SC2 / AT6 devices are designed and manufactured for control applications and air quality compliance in
commercial buildings and manufacturing plants.
13.1 Installers' Responsibilities
It is the installer's responsibility to ensure that all SC2 / AT6 devices are installed in compliance with all national and
local codes and OSHA requirements. Installation should be implemented only by technicians familiar with proper
installation techniques and with codes, standards and proper safety procedures for control installations and the latest
edition of the National Electrical Code (ANSI/NFPA70).
The equipotential bonding required (also e.g. secondary potential to earth) or grounding measures must be carried out
in accordance with the respective project requirements. It is important to ensure that no ground loops are formed to
avoid unwanted interference in the electronic measuring equipment.
It is also essential to follow strictly all instructions as provided in the user manual.
13.2 Maintenance
It is recommended to check the SC2 / AT6 devices regularly. Due to regular maintenance any performance deviations
may easily be corrected. Re-calibration and part replacement in the field may be implemented by a qualified technician
and with the appropriate tools. Alternatively, the easily removable plug-in sensor cartridge with the sensor element may
be returned for service to INTEC Controls.
13.3 Limited Warranty
INTEC Controls warrants the SC2 / AT6 devices for a period of one (1) year from the date of shipment against defects
in material or workmanship. Should any evidence of defects in material or workmanship occur during the warranty
period, INTEC Controls will repair or replace the product at their own discretion, without charge. This warranty does
not apply to units that have been altered, had attempted repair, or been subject to abuse, accidental or otherwise. The
warranty also does not apply to units in which the sensor element has been overexposed or gas poisoned. The above
warranty is in lieu of all other express warranties, obligations or liabilities.
A pre-authorized RMA number is required for returns.
This warranty applies only to the SC2 / AT6 devices. INTEC Controls shall not be liable for any incidental or
consequential damages arising out of or related to the use of the SC2 / AT6 devices.
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Advertisement
Table of Contents
