D+H CDC 200 -BSY+ Original Instructions Manual page 2

Hide thumbs Also See for CDC 200 -BSY+:
Table of Contents

Advertisement

WARNING
Read all safety warnings, instructions, illustrations
and specifications provided with this product.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
Safety notes
Safety extra low voltage 24 V DC!
Do not connect directly to the mains supply!
- Connection must be carried out by a certified
electrical technician
- Danger of crushing hands and fingers!
- Keep people away from the operating area of the
drive
- Keep children away from the control
- Observe pressure load diagram of the chain
- Use only in dry rooms
- Suitable for indoor mounting only. Use rain
detector in locations if there is a risk of rain
- Use unmodified original D+H parts only
Observe enclosed red safety note!
Scope of supply
Drive unit with 2.5 m silicone cable. Depending on
the type of window, different bracket sets are
available separately.
Chain type
The mounting instructions for the bracket
set must be observed before mounting.
Always observe and comply with the
information in the mounting instructions.
Attention with side bow chains SBD and SBU
Standard chain
Side bow chain
6/20
CDC 200/350(-SBD)-BSY+
Side bow chain
-SBD
-SBU
Intended use
- Chain drive for electric opening and closing of
windows and flaps in the facade and roof area
- Operating voltage 24 V DC
- Usable for smoke extraction, D+H Euro-SHEV in
accordance with DIN EN 12101-2 as well as daily
ventilation
- Suitable for indoor mounting only
Features
- Microprocessor-controlled synchronous
electronics BSY+ for safe and precise
synchronous running of up to 8 drives
- Individually programmable via software SCS
- Especially quiet motor running in ventilation mode
- Protection system for the main closing edge
- Rated voltage and Bus-signals loopable for max.
3 drives
- Power supply from left or right
- Relief of pressure on window gasket after closing
- Direct connection of an additional closing edge
pinch protection ledge to drive is possible
(Option -SKS)
Pressure load diagram
Observe maximum pressure load of the chain!
Maximum pressure load of chain is not automatically
identical with maximum pressure force of the drive!
250
200
150
100
50
-SBD / -SBU
English
Stroke (mm)
Standard
99.823.67 2.6/03/16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdc 350-sbd-bsy+Cdc 350 -bsy+Cdc 200-sbd-bsy+Cdc 200/350 -bsy+Cdc 200/350 -sbd -bsy+

Table of Contents