Download Print this page

Briggs & Stratton P4500 Operator's Manual page 3

Hide thumbs Also See for P4500:

Advertisement

Connect Battery
You must connect the battery to the generator to enable
electric or remote starting. The display panel, LED's and
e-choke system are powered by the battery also.
1. Remove screw and panel from in front of the battery.
2. Connect the two pin connector from the battery to the
generator.
Pairing Remote Start Fob to the Generator
The remote start fob needs to be paired with the generator
to remotely start your generator. To pair the fob with the
generator, follow the instructions below:
1. Press and hold the activate switch for 10 seconds and
the on/off button light will begin to flash blue.
Activate Switch
2. Within 30 seconds, press and hold either button on
the remote start fob for 2 seconds. The on/off button
light will blink rapidly 3 times signaling the remote start
fob has been paired.
NOTICE All remote start fobs can be disconnected by
pressing both the on/off button and activate switch on the
generator at the same time for 10 seconds.
InfoHub™ Portable Wireless App
Download the InfoHub Portable App* to pair the
Bluetooth® enabled generator to your approved Android or
iOS smartphone and follow the in app instructions.
The generator is equipped with a status LED (located
under QPT button) to indicate the Bluetooth status. A
blinking blue LED indicates the generator is ready to be
paired to the App on your smartphone. A solid blue LED
indicates your generator is connected to the App on your
smartphone. A red LED indicates a fault in the generator's
Bluetooth system, contact your closest Briggs & Stratton
authorized service dealer.
The InfoHub Portable App allows you to access information
about your generator directly through your smartphone.
The power usage displayed in the app is a percentage of
total generator output. Each receptacle is limited by the
receptacles capacity and circuit breaker. See Connecting
Electrical Loads.
* Data rates apply
The Bluetooth® word mark and logos are registered trademarks owned
by the Bluetooth SIG, Inc. and any use of such marks by Briggs & Stratton
Corporation is under license. Other trademarks and trade names are
those of their respective owners.
On/Off Button
Equipment Description
3

Hide quick links:

Advertisement

loading

This manual is also suitable for:

030807