Related Manuals for Idex Banjo 150P-3
Summary of Contents for Idex Banjo 150P-3
- Page 1 SELF-PRIMING POLY CENTRIFUGAL PUMPS INSTRUCTION MANUAL 1½″, 2″ & 3″ PUMPS BANJO CORPORATION A Unit of IDEX Corporation 150 Banjo Drive, Crawfordsville, IN 47933 U.S.A. banjocorp.com | Telephone: (765) 362-7367...
-
Page 2: Operation Warning
OVERVIEW Read these instructions and the instructions covering operation of the pump drive unit. The gas engine (if so equipped) is shipped with no oil. Consult your owners manual for specific oil recommendations, maintenance procedures, schedules, and troubleshooting. The maximum angle of operation for gas engine drive units is 25°... - Page 3 P ER F O R M A N CE 1½″, 2″ & 3″ POLY PUMPS 1½″ Port Size Suction .......1½″ NPT Discharge ......1½″ NPT 2″ Port Size Suction ........2″ NPT Discharge ......2″ NPT PERFORMANCE CHART @3450 PERFORMANCE CHART @3450 PERFORMANCE CHART @3450 PERFORMANCE CHART @3450 PERFORMANCE CHART @3450 PERFORMANCE CHART @3450...
- Page 4 DI SA S S E M B LY I N S TR U CT IO NS: Remove the 10 body screws (12720), lock washers (V07018) and Remove the check valve (12705) from the volute (12702A/13702). nuts (V07019) from the pump assembly. Remove the body from the pump assembly.
- Page 5 DI SA S S E M B LY I N S TR U CT IO NS: Remove carbon seal half from rear bracket with a round object. Tap At this time, it may be necessary to polish the drive unit shaft to gently with a hammer.
- Page 6 A SS E MB LY I NS T R U CTI O NS: Install the rear bracket onto the drive unit using the bracket screw Verify impeller hex nut (12775A) is located at the bottom of impeller snout (should be installed). A very light press fit may be required to assemblies from the previous step.
- Page 7 (V07018), and 10 nuts (V07019) to secure the pump body to the rear bracket. Tighten the bolts securely all the way around. Please see banjocorp.com for more information BANJO CORPORATION A Unit of IDEX Corporation 150 Banjo Drive Crawfordsville, IN 47933 U.S.A. Telephone: (765) 362-7367...