Advertisement
A.
UNPACKING AND INSPECTION
1. Carefully remove the GRIDDLE from the carton. Remove all protective plastic film, packaging
materials and accessories from the GRIDDLE before connecting electrical power or otherwise
performing any installation procedures.
NOTE: DO NOT discard the CARTON and other PACKAGING MATERIAL until you have
inspected the warmer for hidden damage and tested it for PROPER OPERATION.
Refer to SHIPPING DAMAGE CLAIM PROCEDURE on page 1 of this manual.
2. Carefully read all instructions in this manual and the INSTALLATION INSTRUCTIONS packed with
the warmer before starting installation of this warmer. READ AND UNDERSTAND ALL LABELS
AND DIAGRAMS ATTACHED TO THE GRIDDLE.
3. Carefully account for all components and accessories before discarding packing materials.
Store the accessories in a convenient place for later use:
B.
SET-UP
1. Setup the griddle only on a firm, level surface. Non-combustible material (e.g. metal, terrazzo) is
recommended.
2. Maintain clearances between the appliance and adjacent combustible surfaces. Avoid storing
combustible or flammable materials near the appliance.
3. Legs must be properly installed and the griddle levelled . Move the griddle carefully to avoid damage
to the legs.
4. Install grease drawer and splash guard prior to using griddle.
C.
ELECTRICAL HOOK-UP
IMPORTANT: Electrical installation must be performed by a licensed electrician in compliance
with all local ordinances and code requirements.
1. Refer to the nameplate. Verify the electrical service power. Voltage and phase must
match the nameplate specifications. Connecting the griddle to the wrong voltage can severely
damage the unit or cause noticeably decreased performance.
IMPORTANT: Damage due to being connected to the wrong voltage is NOT covered by warranty.
2. Use copper wire suitable for at least 90ºC for supply connections.
3. Griddles are factory wired three-phase (3ø). For single-phase (1ø) wiring, refer to the wiring
diagram attached to the griddle.
4. This griddle is not fused. Protect the circuit with properly sized fuses or circuit breaker.
5. An electrical disconnect must be installed readily accessible to the operator of the griddle.
INSTALLATION INSTRUCTIONS
CAUTION: Electrical Shock Hazard
This griddle must be electrically grounded.
Connect the terminal marked " GND" or "
G
" to a suitable building ground.
4
Advertisement
