Copy Function - Johansson Profiler SAT User Manual

COPY FUNCTION

This function allows to transmit all settings from one unit to another unit.
All actions have to be done on the SLAVE unit.
The MASTER unit remains in Stand-by.
B I-II
I-II
+
15V IN
- Connect master and slave unit with a DSUB9 male/male crossed cable.
- Then connect mains to the units.
- Push on the rotary button for more than 3 seconds to enter into programming mode.
- Turn the button to select the Data Import mode.
- Push the rotary button to enter the selected mode.
- Push the rotary button to confirm Data Import.
Note :
If a problem occurs during data transmission the display will show an error message :
Possible causes are : wrong type of cable, no cable, bad pin contacts.
0
B III VHF-UHF UHF1 22 kHz UHF2 UHF3
24V 24V 18V 24V 24V
SAT
13V
0V
III V-U 1 2 3 4 5 6 7 8 9 10
UHF Clusters
SAT
GND
R
MULTI CHANNEL
PROGRAMMABLE FILTER-AMPLIFIER
Digital
Terrestrial
Ref.: 6602
Stop Channel Manual Level
SAT Slope
Start Channel Auto Level
SAT ON / OFF
Select Filter Data Import
Split UHF Exit
Output Test
(-30 dB)
SLAVE
15V
Data
The software version is displayed,
followed by a dot.
3sec.
Data Import
The LED is green.
Data Import
The LED is now RED colored.
AL is displayed
The software version is displayed,
followed by a dot.
16
0
B I-II B III VHF-UHF UHF1 22 kHz UHF2 UHF3
24V 24V 18V 24V 24V
SAT
13V
0V
I-II III V-U 1 2 3 4 5 6 7 8 9 10
UHF Clusters
SAT
GND
R
MULTI CHANNEL
PROGRAMMABLE FILTER-AMPLIFIER
Digital
Terrestrial
Ref.: 6602
Stop Channel Manual Level
SAT Slope
Start Channel Auto Level
SAT ON / OFF
Select Filter Data Import
Split UHF Exit
+
IN
Output Test
(-30 dB)
MASTER