Install New Power Supply - Honeywell PS1202A Installation Instructions Manual

PS1202A REPLACEMENT POWER SUPPLY KIT FOR ELECTRONIC AIR CLEANER
REMOVING COVER
FROM POWER BOX.
2
1
Fig. 1. Remove cover from power box.
 Disconnect the leads from the old power supply. See
Fig. 2 through 5.
Fig. 2. Power supply location on F50F and F58F.
 Remove and discard W8600E terminal block and
wiring. Set aside screws for later use.
 Remove and set aside the sheetmetal screws holding
the board in place.
 Discard the old power supply.
69-1136EF—01

Install New Power Supply

 When replacing the power supply, reuse the remaining
 Install W8600E terminal block and wiring supplied with
 Align the mounting holes and mount the new power
 Route the remaining leads so the P3 and P4 leads are
 Connect leads to the terminals on the new power
IMPORTANT
3
 Plug the electronic air cleaner directly into the correct
M5676A
NOTE: To reduce the risk of electric shock, this
CHECKOUT
IMPORTANT
With all components in place, turn on the air cleaner
switch and energize the system blower. Check the
following points of operation:
POWER
1. The neon light next to the on-off switch is on. If a
SUPPLY
M33488
2. Turn off the system blower. The neon light should
3. Turn on the system blower. With the air cleaner
4. With a multispeed blower, repeat steps 1 through 3
5. If operation is not as described, refer to the Trouble-
2
leadwires in the air cleaner when removing the old
power supply.
this kit using screws previously removed.
supply in the air cleaner, using the sheetmetal screws
removed earlier. Orient the power supply so P1 and P2
are toward the front (closest to the switch and neon
light).
separate from the low voltage leads. Route all high
voltage leads around, rather than over, the power
supply board. Low voltage leads can go over the power
supply board.
supply.
Do not splice ionizer and collector leads. These
leads must be unbroken to avoid electrical shock
through the connector or tape covering the
splice.
voltage and frequency outlet or reconnect power for
directly wired devices. See Fig. 3 or 4 for internal
schematic. The air cleaner operates correctly at any
fan speed on a multispeed or modulated speed system
wired with conduit or plugged in.
product has a grounding type plug with a
third (grounding) pin. This plug fits only into
a grounding type power outlet. If the plug
does not fit into the outlet, contact a qualified
electrician to install the proper outlet. Do not
change the plug in any way.
The following instructions are for use only by
qualified personnel.
W8600E is part of the installation, check the wall
panel and make sure the ON LED is lighted. The
W8600E CHECK LED comes on if there is a prob-
lem with the high voltage power supply.
go off after a few seconds. The neon light shows
that the air cleaner is energized and the high volt-
age power supply is working properly.
energized, push the test button. A snapping sound
indicates that the collector voltage is present on the
cell. The W8600E CHECK LED comes on when the
test button is held down.
for each fan speed.
shooting and Service section.