Maintenance - TACKLIFE PMS01X User Manual

Maintenance

WARNING: Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
When all the adjustments, settings or maintenance have been done, make sure that all keys and
wrenches have been removed and that all screws, bolts and other fittings are securely tightened.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of dust. Occasionally you may see sparks
throughK2the ventilation slots. This is normal and will not damage your power tool.
If the supply cord of this power tool is damaged, it must be replaced by a specially prepared
cord available through the service.
1. PRECISION SETTING OF ANGLES (SEE FIG J1 ,J2，K1，K2)
While the machine has been factory set, it is advisable that the 0o setting of the rotary table and the 90o
perpendicular setting of the tilt be checked, as these positions may have moved in transit. (Ensure power
is disconnected while making these adjustments).
To confirm the 0o rotary table setting, set the rotary table at 0o and tighten the rotary table locking knob.
Check that the angle between the straight guide and the blade is 90o using a try square (b, not supplied)
as shown in Fig. K1. If the angle requires adjustment, loosen the locking screws for straight guide, and
align the fence against the try square.
Re-tighten theblocking screws for straightLguide. (SEE FIG J1, J2)
Similarly, check that the angle of the blade to the face of the rotary table is 90o. If necessary,adjust the tilt
angle of the saw head at the 90o position: loosen the bevel lock (19) and adjust the 0° bevel adjustment
screw (c) to bring the saw blade into alignment with the square. Loosen the head screw (c) holding the
pointer of the bevel scale (20) and adjust the position of the pointer so that it accurately indicates zero on
the scale. Retighten the screw. Retighten the bevel scale (20) and the 0° bevel adjustment screw . (SEE
FIG K1, K2)
10