Dmx Control - BoomToneDJ Cirrus 1000 User Manual

DMX control

Connect the fog machine to your DMX-controller, using standard XLR male to XLR female
cables. Select the correct DMX starting address by using the control panel just above the
XLR-connectors.
Turning on the machine Plug in the power cable on the rear of the machine. When doing
so, you will not have instant smoke as the internal heating element needs to reach a
certain temperature. The wired timer remote shows a 'ready' indication, with a green
LED.
Channel
Ch1
Ch2
Clogged system
It is possible that the fog output of your machine decreases over time. This may be
caused by congestion in the fluid pump system. To solve this, you have to follow the
steps described below first. Do not use special fog machine cleaning solutions first, as
these are the last expedients to save your fog machine. - If there is any fog liquid left in
your tank, remove it from the tank. - Fill the fluid tank with demineralized/distilled
water.
WARNING: Never use tap or normal bottled water as this contains chalk. This may clog
your system, causing permanent damage.
- Fill the tank with approximately 1 liter demineralized/distilled water.
- Turn on the machine and let the heating process take place
- When your fog machine is ready, let the machine work at 100% output, continuously.
This can be done through DMX or with the timer remote control.
- You will notice that the first couple of output-bursts the machine mainly produces fog.
This is caused due to the fog liquid that is still inside the pipes of the heating system.
After several minutes you will notice that the fog output smoothly transforms into a
light steam solution. This means that the demineralized or distilled water has been
pumped around the machine.
Description
Fan 0-100%
Fog output 0-100%
8