TAB-Austria Golden Island VC2 Operator's Manual page 49

Before a PIN can be activated, a correct 4-digit number must have been assigned (after a
MASTER RESET all PIN are deleted). If a PIN is to be inserted or changed, the desired
authorisation level is chosen and after that the PIN is entered twice. After correct entry the
activation box is available.
To change or (de)activate the operator PIN, it must be inserted beforehand for security
reasons. If a PIN has been deactivated, a lock symbol is displayed in the field of the supervisor
concerned. After choosing the locked supervisor the lock starts flashing. The locked PIN is
released by pressing the button „Release PIN".
Releases can only be carried out with a higher authorisation level than that of the one to be
released.
If a PIN is changed it is saved IMMEDIATELY, the activation happens as soon as the button
„Accept" is pressed.
A locked PIN is automatically released after one hour.
If an operator has locked its PIN it can only be released by entering the 8-digit Operator- PUK.
After the correct entry a new PIN must be inserted. You can find the Operator-PUK on last
page of this manual (see Operator-PUK). If you have not got the Operator-PUK at hand, you
can receive it from TAB after naming the Hardlock-Dongle serial number visible on the operator
start page.
The setting „Access Operator Mode" in the section „Head Supervisor" defines if the head
supervisor has access to the operator mode (can only be activated, if the PIN for the operator
and the head supervisor are activated).
Page 49