Weider WESY5773.0 User Manual page 9

12. Press two 25mm Square Inner Caps (54) into the
indicated end of the Backrest Frame (15).
Attach a Plastic Foot (53) to the Backrest Frame
(15) with an M4 x 16mm Screw (62).
Attach the two Guard Plates (17) to the inside of
the Backrest Frame (15) with four M4 x 16mm
Screws (62).
13. Orient the Backrest (14) and the Backrest
Backing (8) as shown. Attach the Backrest and
the Backrest Backing to the Backrest Frame (15)
with four 1/4" x 45mm Button Screws (58).
Insert the rod on the Backrest Frame (15) into the
slot in the Seat Carriage (12). Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
14. Attach the two 10-pound Short Caps (20) to the
10-pound Center Resistance Bar (44) with two
M4 x 12mm Flat Head Screws (85).
Using twelve M4 x 12mm Flat Head Screws (85),
attach the two 10-pound Caps (101) to the 10-
pound Removable Resistance Bar (67), the two
20-pound Caps (88) to the 20-pound Removable
Resistance Bar (36), the six 80-pound Caps (100)
to the two 80-pound Resistance Bars (95) and the
80-pound Top Resistance Bar (105), and the two
40-pound Caps (79) to the 40-pound Resistance
Bar (96).
15. Orient the Cover Plate (72), with the edges up.
Attach the 80-pound Top Resistance Bar (105) to
the Cover Plate with the two 1/4" x 25mm Screws
(108). Note: The Top Resistance Bar is closer
to the back of the Cover Plate.
12
54
17
62
17
13
14
8
15
58
14
36
67
44
85
15
Edges
up
72
9
15
53
62
62
15
Rod
12
105
96
95
85
85
100
85
88
85
101
20
105
Back
108
Slot
100
79