Fender Super Champ XD Instructions Manual page 7

5. Trim the other end of the capacitor pair
to reach to the midway point on the bare
jumper between J5 pin 5, and J5 pin 11.
Slide piece of HST over this lead to cover
th
all but 1/16 inch at the end. Form a
hook in the end of this lead and clamp it
around the jumper and solder. See
circled area in Figure 13. Shrink all HST
in place. NOTE: If your .03 µF cap
doesn't reach, you will need to add
enough wire so it may be connected as
shown.
To stabilize the flying components and wires, tie them off with
lacing twine or cable ties at the points shown in Figure 14.
Assemble the chassis into the cabinet in reverse order of disassembly. When re-assembling
chassis into cabinet, make sure all components and wires are below the chassis edges so they
aren't able to contact the cabinet. Remember, the cabinet is lined with foil in the chassis area!
Here is how I re-labeled
the two affected controls
on the front panel:
Figure 14 (a and b)
Figure 13