Fender Super Champ XD Instructions Manual page 6

WIRING TO R84
1. Cut a wire about 4" long. Strip about 1/8" from one end and ¼" from
the other. Bend the ¼" stripped portion to 90º in relation to the insulated
part. Tin both ends and the three terminals of R84.
2. Solder the 1/8" stripped end to the
bare wire between the 10K resistor
and P5, pin 1, close to the resistor as
shown in Figure 11 (refer to Figure 7
also).
3. Solder the ¼" tinned end
to terminals A and B of R84
as shown.
4a. Slide piece of HST over the entirety
of one lead of the .03uF capacitor pair
created in a previous step to cover all but
th
about 1/6 inch at the end.
4b. Solder this end to terminal C of R84.
R84
A B C
Figure11
A
B
C
R84
Figure 12