Installation - Monster IlluminEssence Prism Quick Start Manual

INSTALLATION

STEP 1
Before installing anything, try out di erent shapes and patterns
with your panels on the floor or a large table to decide what you
would like to create! Consult the Design Guide for ideas.
examples:
IMPORTANT:
• Plan to install your Prism near enough to a power outlet.
• Place the controller on the left side of your pattern on the
RED end of one connector.
• To ensure all panels light up, make sure all the connectors
always point GREEN side AWAY from the controller.
DESIGN TIP: Pointing the directional markers on the back of each panel
towards or away from each other will create di erent lighting e ects when
panels are combined, but you can easily change this after installation!
STEP 2
First, clean the mounting surface with rubbing alcohol and let dry.
When you're ready to start, peel o the adhesive backing from
one Prism panel, position the panel on the wall where you would
like to begin your pattern, and press gently on the center.
NOTE: Do not attach this product to wallpaper, brick, the ceiling, or the floor.
If desired, you can use a level to help align and place this first panel.
PRESS
GENTLY
5