SOMFY P03 Operating Instructions Manual
SOMFY P03 Operating Instructions Manual

SOMFY P03 Operating Instructions Manual

For climax / as 315n

Advertisement

Quick Links

Weather Station P03
for Climax / AS 315N
Operating Instructions
Rev. 01-03/2009 vm
1
Page
© by Somfy GmbH

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P03 and is the answer not in the manual?

Questions and answers

Summary of Contents for SOMFY P03

  • Page 1 Weather Station P03 for Climax / AS 315N Operating Instructions Rev. 01-03/2009 vm Page © by Somfy GmbH...
  • Page 2: Table Of Contents

     When installing, it is important that the temperature sensor (a small chip on the underside of the housing) is not damaged.  The wiring connections between the chip and rain sensor must not be torn off or bent. Page © by Somfy GmbH...
  • Page 3: General

    To be able to take full advantage of the fault-free functions of the product please read through these operating instructions carefully. Somfy can not be held liable for faults and damages due to wrong use or neglected operating instructions (wrong installation, wrong start-up, incorrect operation, etc.).
  • Page 4: Components

    Brightness sensor Brightness / twilight sensor Wiring inlet Temperature sensor Wind sensor (heated) Connection rain sensor Connection control cable +24V DC data LED DCF signal setting DCF antenne Brightness sensor Brightness sensor Brightness / twilight sensor Page © by Somfy GmbH...
  • Page 5: Installation

    2.1.2 Installation of the wall or mast holder • secure the holder vertically on the wall or mast. With wall installation: • Install the holder with the flat side facing the wall. The shoulder (1) must be facing upwards. Page © by Somfy GmbH...
  • Page 6: Drilling Plan For Holder

    Ø 5 mm 22 mm 7,5 X 5 mm 2.2 Electrical connection Note: The top housing part of the Weather Station with the rain sensor is clicked-in left and right on the under edge of the base. Page © by Somfy GmbH...
  • Page 7 30m in length. The connection is made with standard telephone cable, (J-Y(ST)Y 2 x 2 x 0,8). +24V DC data Weather Station 9015079 Inside temperature sensor 9001461 EIB BUS cable KNX/EIB- Kombisensor AS 315N DATA Branch EXT . socket Mains Page © by Somfy GmbH...
  • Page 8: Positioning Of The Dcf Antenna

    When the wind sensor is subject to a lot of dirt it may malfunction by recognising a continuous rain message or that there is no more sunshine. Attention: When servicing the Weather Station and damage is identi- fi ed, it must be taken out of operation. Page © by Somfy GmbH...
  • Page 9: Notes

    4 Notes __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ __________________________ Page © by Somfy GmbH...
  • Page 10 Tel.: +43 (0)662 625308 0 Fax.: +43 (0)662 625308 22 e-mail: offi ce@somfy.at Switzerland Somfy AG Vorbuchenstrasse 17 CH-8303 Bassersdorf Telefon +41 44 838 40 30 Fax +41 44 836 41 95 e-mail: support@somfy.ch Rev. 01-0403/2009 vm Page © by Somfy GmbH...

Table of Contents