Advertisement
Off/Rec：Please press Off/Rec button to remove SD card. Please remove card within 30 seconds
of pressing the Off/Rec button to avoid loss of data.
Step 5. Set the Data and Time
This will allow the security video taken by NightWatcher NE400 to display the correct date and time
it was taken.
1. Push TIME/DATE SET button (see fig. 11) for 3 seconds, The LCD screen will then flash 3 times,
indicating you have entered Time/Date setting mode.
"YEAR"setting：
1.
99", push the button again and hold for 3 seconds to scroll through numbers quickly. If you have not
pressed the button for 3 seconds, it will automatically save the year and go on to allow you to set the
month.
2.
Repeat the same setting procedure for
"VIDEO/PHOTO "setting：
3.
icons
and "V" appear on the screen；push the button to choose "V"（Video）or "P"（Photo）
. If you have not pushed any buttons for 3 second, "OK" will appear on the screen, indicating it has
automatically saved the current settings. The LCD screen will shut off automatically 10 seconds later.
* On the "P" (photo) setting, NightWatcher NE400 will take a series of digital photographs at a rate of 3
photos every second when the motion sensor is triggered.
①
③
⑤
⑦
Step 6. Viewing video
1. Viewing image by computer through a card reader (see fig. 12)
Open the waterproofed cover on the NightWatcher NE400 Motion Light with Video Camera
Press OFF/REC button and remove SD cardfrom the slot.
Fig. 11
"Y" and "08" are displayed on the screen; push the button to set year from "08-
MONTH/DATE/HOUR/MINUTE.
when entering this mode, these two
②
Start
④
MONTH
Setting
⑥
HOUR
Setting
VIDEO/
⑧
PHOTO
Setting
：
YEAR
Setting
DATE
Setting
MINUTE
Setting
Finish
Advertisement
