Advertisement
Step2. Installing the NightWatcher NE400 Motion Light with Video
Camera
IMPORTANT
IF IN ANY DOUBT ABOUT THE INSTALLATION OF THIS PRODUCT, CONSULT A QUALIFIED ELECTRICIAN
- This product must be grounded
- Do not mount the unit against inflammable surfaces
- The motion detector will not operate correctly if it is installed:
Near the outlet of a central heating boiler
Near air conditioning plant
Pointing directly at moving vehicles
Within sight of reflections from moving water
Where other lamps could shine on the detector
BEFORE ATTEMPTING ANY INSTALLATION OR MAINTENANCE, ENSURE THAT THE ELECTRICAL SUPPLY IS
SWITCHED OFF AND THE CIRCUIT FUSES REMOVED OR THE CIRCUIT BREAKER IS IN THE OFF POSITION.
Please make sure the voltage and polarity are correct before connection. Incorrect voltage may cause
electric shock. If you are not sure, please contact your retailer.
Note: It is recommend to mount NightWatcher NE400 Motion Light with Video Camera 2M above
the ground for optimum performance, do not mount the fixture below 1.2M. See below figure for
details of performance range.
Detection range: 10M x 160° (see fig. 5)
Installing your NightWatcher NE400 Motion Light with Video
Camera on surface. (see fig. 5 & fig. 6)
1. Place plastic masonry plugs into desired surface aligning holes as shown below. Using an electric
screwdriver, fasten mounting plate directly to surface using screws E.
2. Feed the cable through the back mounting box and bush the cable entry to avoid abrasion to the cable.
3. Wire the unit as follows: (Ensure all wires are connected securely and that no loose strands are exposed)
Fig. 4
Advertisement
