Cleaning The Brush - TECHWOOD TAB-325 Instruction Manual

Hepa filter and sponge filter
Remove the Hepa filter and the sponge filter (the second, located inside the
cyclonic system.) (1).
Wash under running water. (2)
Allow to dry in the open air. (3)
Reinstall the filters before next use. (make sure the 2 Hepa and sponge filters are
dry before reinstalling them).
Note: If any of the filters are damaged or dirty, replace it with a new filter.
If the brush is obstructed, by wires or dirt, the suction will be less good.
Stop, disconnect from stand and turn the rotating brush. Carefully use a pair of
scissors, or a knife, to remove annoying items such as wires or hair that may have
clogged the brush inlet.
If needed, locate the Lock / Unlock button on the
motorized brush shaft (1) And push outward to
release the roll.
Lift (2) and remove the brush roll.
Clean it.
Return it to the original position and close the Lock
until "click".
- Ensure the unit is completely cool and dry.
- Do not wrap the cord of the charger around the appliance, as this will cause
damage.
- Keep the appliance in a cool, dry place and out of reach from children.

CLEANING THE BRUSH

STORAGE
9