Charging The Battery - TECHWOOD TAB-325 Instruction Manual

Assemble the Vacuum / Brush connection tube by inserting the tube into the
upper part of the brush and into the lower part of the appliance until it clicks into
place.
To remove the tube, press the release button with one hand and pull the tube with
the other hand.
NOTES: It is possible to directly assemble the vacuum cleaner and the brush
without using the tube. To do this, proceed in the same way with the tube (upper
part of the brush) and the vacuum cleaner.
It is possible to assemble the accessory
2 in 1 to suck furniture, pillow, nooks etc. by
inserting it carefully Either into the tube,
either directly to the base of the device.
Connect the charger to the unit (make sure the unit is off), then connect it to the
AC outlet. When the unit is plugged in, the indicator light flashes.
It takes about 3 hours to fully charge the battery before the first use.
The indicator light will be fix when the battery is fully charged.
Notes: Always leave the device on its stand (with the charger) when is not used.
This is to ensure that it will always be ready for use.
The charger may become hot during charging, this is normal.
MOUNTING

CHARGING THE BATTERY

7