Advertisement
9.
Press a 2" Square Inner Cap (28) into the Press Seat
Frame (7).
Slide the bracket on the Press Seat Frame (7) onto
the indicated 5/16" x 2 1/2" Carriage Bolts (92) in the
Press Base (6). Hand tighten two 5/16" Nylon
Locknuts (64) onto the Bolts. Do not tighten the
Nylon Locknuts yet.
Attach the Press Seat Frame (7) to the Press Upright
(2) with two 5/16" x 2 3/4" Bolts(89), two 5/16"
Washers (36), and two 5/16" Nylon Locknuts (64). Do
not tighten the Nylon Locknuts yet.
36
10. Lubricatethe 3/8" x 3" Bolt (88). Attach the Leg Press
Lever (83) to the Press Base (6) with the Boltand a
3/8" Nylon Locknut (50). Do not overtighten the
Nylon Locknut; the Leg Press Lever must pivot
easily.
11. Place two Weight Bumpers (51) over the indicated
holes in the Weight Base (5). Slide a Weight Guide
(15) into each of the holes.
Attach the indicatedWeight Guide (15) to the Weight
Base (5) with a 3/8" x 2 3/4" Bolt (46), two 3/8" Flat
Washers (48), and a 3/8" Nylon Locknut (50).
Slide six Weights (21) onto the Weight Guides (15).
Make sure the Weights are turned so the pin
grooves point towards the floor.
Press a Weight Tube Bumper (18) intothe lower end
of the Short Weight Tube (17). Slide the Weight Tube
into the center holes in the Weights (21).
Slide a Top Weight (16) onto the Weight Guides (15).
Note: Make sure the Top Weight is turned so the
groove fits over the welded pin on the Weight
Tube (17).
8
Advertisement
