Advertisement
Note: This introduction
will save you more time
than it takes to read itl
MaDdr_ _lngs _Ser for_yo.rs=_i
by anyone. However,;iHs_i_to_ealize'
,
tl_t your newequi . _..:is
a,_
prod- _
wm take_
_
houm.!Mo= peo-
by.deddlrig tomakethe.ta_ eejWal_i, u sam--
bWy _1iOo:=_==li_s:Y=;J
iiiis want i o'ix_nplete .
the precessover_tooupieof eventhg_
,
'_.
Some assembly steps require two people.
Giving Yourself a Good Start
Before you begin the assembly process itself, take
the bme to complete the steps outlined here.
Clearing the Workspace
Clear a workspace that is large enough to hold all
parts and allow you to walk all the way around the
assembled equipment.
Unpacking the Box
To make the assembly process as smooth as possi-
ble, we have broken it into separate stages. All parts
used in each stage are found in individualpackages
in the shippingbox. Place all parts in a cleared area
and remove the packing materials. Do not dispose of
the packing materials until assembly _scompleted.
Important: Wait until you begin each assembly
stage to open the parts bag labeled for that
assembly stage,
Identifying Parts
To help you identifythe small parts used in assem-
bly,we have included a PART IDENTIFICATION
CHART located in the center of th_smanual. Place
the chart on the floor or work table and use it to
quickly identify different parts as you open the pack-
ages for each step. Note Some small parts may
have been pra-attached for shipping. If a part is not
in the parts bag, check to see if it has been pre-
attached.
Orienting Parts
As you assemble this product, be sure that all parts
are oriented as shown in the drawings.
Tightening Parts
Tighten all parts as you assemble them, unless
instructedto do otherwise.
Lining Up the Tools
Assembly requires the following tools (not included):
• Two (2) adjustable wrenches
• One (1) standard screwdriver
• One (1) phillipsscrewdriver
• One (1) rubber mallet
• Lubricant,such as grease or petroleumjelly,
and soapy water
• Tape, such as clear tape or maskingtape
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-endwrenches
or a set of ratchet wrenches.
The Four Stages of the Assembly
Process
Frame Assembly
You will begin by assembhng the base and the
upright frames that serve as the skeleton of the
equipment.
Cable Assembly
This assembly COmpletesthe cables and pulleys
that connect the moving arms with each other and
with the weights.
Arm Assembly
This assembly completes the press and butterfly
arms that you operate while you are exercising.
Seat Assembly
This assembly completes the seat and backrest
that supped your body while you are exercising.
4
Advertisement
