Safety Instructions - Fluke i50s User Manual

i50s
Users Manual

Safety Instructions

Please read this section carefully. It will make you familiar with the most
important safety instructions for handling your product. In this manual, a
identifies conditions and actions that pose hazard(s) to the user. A
Warning
Caution identifies conditions and actions that may damage the Probe, Power
Supply, or the test instruments.
The Probe and Power Supply may only be used and
handled by qualified personnel. To avoid electrical shock
or personal injury, follow these precautions:
•
Use caution during installation and use of these
products; high voltages and currents may be present
in circuits under test.
•
Do not use the Probe or Power Supply if damaged.
Always connect the Probe to display device before it is
installed around the conductor.
•
If the Probe or Power Supply is not used in a manner
specified by the manual, the protection provided may
be impaired.
•
Use the Power Supply only with i50s Current Probes.
•
Do not use the Probe without consulting local and
national safety codes and use of protection equipment
is recommended.
•
Do not hold the Probe beyond the tactile barrier (see
Figure 1).
•
Before each use, inspect the Probe and Power Supply.
Look for cracks or missing portions of the housing or
output cable insulation. Also look for loose or
weakened components. Pay particular attention to the
insulation surrounding the jaws.
•
Use caution when working with voltages above 60 V
dc, 30 V ac rms or 42 V ac peak. Such voltages pose a
shock hazard.
•
Do not use the Probe or Power Supply in wet
environments or in locations that hazardous gases
exist.
•
Inspect the Power Supply and power cord and ensure
that they are not damaged.
•
This product has no serviceable parts, do not open the
Power Supply.
•
Check to make sure that the voltage selector switch on
the back panel of the Power Supply is set to the correct
mains input voltage before connecting power.
2
WX
Warning